Hitachi 32HDT20 Operating Manual page 38

Operating the precoded function for your Audio component.
This remote is designed to operate different types of Audio component. You must first program the remote to match the remote com-
mand set of your Audio component. (refer to page 39 for pre-codes)
1. Turn ON your Audio component you wish to control with the Remote.
2. Aim the remote control at the front of your Audio component.
3. Press and release the CD, TAPE, or AMP button to switch to Audio component pre-coded mode.
4. Hold down the CD, TAPE, or AMP button on the remote and enter the two digit preset code that matches your Audio component,
as shown on page 39. The CD, TAPE or AMP button light will flash 3 times if the code was accepted.
5. Aim the remote at the Audio component and press the POWER button. The remote will turn off your Audio component if the cor-
rect two digit preset code is entered. When this occurs, the remote control is programmed for your Audio component. If the Audio
component does not turn off, try a different two digit preset code.
6. The remote will now control your Audio component.
7. Repeat steps 1 - 6 if you wish to program the remote to control another Audio component. Be sure to use a different Audio button
on the remote, since only one component can be programmed per button.
NOTES:
1. If your Audio component cannot be operated after
performing the above
component's code has not been precoded into the
remote.
2. In the unlikely event that your Audio component cannot be
operated after performing the above procedures, please
consult your Audio equipment operating guide.
3. The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
CD, TAPE, AMP Buttons
These buttons allow the remote to control your Audio
equipment by setting it to Audio mode.
PRECODED AUDIO Buttons
These buttons transmit the chosen precoded Audio
component codes.
EXCLUSIVE TV Buttons
These buttons are for operating the Plasma TV.
NOTE: Refer to instruction manual of the Audio equipment for operation of the buttons exclusively for the Audio equipment.
TO CONTROL ADDITIONAL AUDIO EQUIPMENT
procedures, your Audio
USING YOUR REMOTE
TV
DVD
SLEEP
PIP MODE
MY AUDIO EQUIPMENT CODE IS:
38
POWER
VCR
CBL
STB
SOURCE WIZARD
CD TAPE
AMP
1 2 3
4
5 6
7
8 9
0
INFO
A/V NET
SELECT
VOL CH
VID 3
PIP PIP CH FREEZE
PIP ACCESS
SWAP
VIDEO
REC
CLU-5723TSI
CD
TAPE
AMP/RCVR