Switches (Hp Jetdirect 300X And 500X) - HP 170X - JetDirect Print Server Hardware Installation Manual

Switches (HP JetDirect 300X
and 500X)
The HP JetDirect 300Xand 500X Print Servers have configuration
switches that should be used only if the print server fails to link on
the network. The factory-default setting of all 3 switches down will
suit most installations. These switches only apply to 10Base-T and
100Base-TX networks only.
When the first switch is set to Auto, the other two switch settings
are ignored; the server auto-negotiates the link speed and duplex
setting with the connected switch or hub device. Even with devices
that don't auto-negotiate, the print server detects the network link
speed and uses half duplex.
Although nearly always unnecessary, you can control the settings
directly by positioning the switches as shown in the table below,
only if you are certain of the duplex setting and speed at which the
switch or hub is operating.
If the auto
switch is
set to...
AUTO
(down)
MANUAL
(up)
MANUAL
(up)
MANUAL
(up)
MANUAL
(up)
In Auto mode, you can see the network speed being
Note
used by checking the LEDs at the RJ-45 connector.
See p.1-8.
And if the
speed switch
is set to...
either position
(default=down)
10 (up)
100 (down)
10 (up)
100 (down)
And if the
duplex switch
is set to...
either position
(default=down)
HALF (down)
HALF (down)
FULL (up)
FULL (up)
Product Overview 1-9
Then the
settings are...
Auto-negotiated
(factory default)
10Base-T
Half-duplex
100Base-TX
Half-duplex
10Base-T
Full-duplex
100Base-TX
Full-duplex