Section 4. Installing Netware On The Hp Netserver - HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade Installation Manual

Copy A:\CDROMDRV\IDEDOS\*.* C:\directoryname
8. Use the edit utility to add the following lines to your CONFIG.SYS file:
DEVICE=C:\directoryname\FDATACD.SYS /D:driver1
Where directoryname is the path to the directory containing the FDATACD.SYS
driver, and driver1 specifies the driver signature name of the first CD-ROM device
driver. The driver signature name must have fewer than eight characters, for example:
DEVICE=C:\DOSCDROM\FDATACD.SYS /D:HPCD000
NOTE: The MSCDEX driver is included with MS-DOS/Windows version 6.0 or
later. The MSCDEX driver also supports a driver signature parameter (for
example, /D:driver1). The name used for this parameter must match the name
used for the FDATACD.SYS driver signature parameter.
9. Use the DOS edit utility to add the following line to your AUTOEXEC.BAT file:
C:\DOS\MSCDEX /D:driver1 /L:logical drive letter
For example, if C:\DOS\MSCDEX.EX /D:HPCD000 /L:E is used, the CD-ROM
drive is assigned to the DOS logical drive E: If you do not use option /L:E, the system
will automatically assign a DOS logical drive for the CD-ROM drive.
10. Power down your HP NetServer.

Section 4. Installing NetWare on the HP NetServer

This section details how to install SCSI, NIC, and HP NetRAID drivers from the NOS
Drivers Diskette created from the HP Navigator CD-ROM detailed in the section
Creating Drivers Diskette.
Netware 4.2 Installation
NOTE: Netware 4.2 installations with 4 GB of memory are known to fail
intermittently. If you have 4 GB of memory in your system, install Netware 4.2
using 3 GB of memory. Then after installation reinstall remaining memory.
NOTE: At least a 250 MB DOS partition must already exist on your hard drive
and your CD-ROM drive should be accessible. For detailed instructions refer to
Installing the CD-ROM Drive in DOS with FDATACD.SYS and MSCDEX.EXE
1. Remove the HP NetServer Navigator CD-ROM and any floppy diskettes from the A:
drive and insert the Novell Netware 4.2 Installation CD into the CD-ROM drive.
.