Before Connecting Components - Yamaha YSP-3000bl Owner's Manual

Connections
Before connecting components
-_
...
_----
• Cables used for connections
AudioNideo
o
HDMlcable
• Affixing cables
To prevent cables from becoming unplugged, place the
supplied cable clamp with the open side facing upward,
attach it to the rear panel of this unit in a suitable position,
and then affix cables in the cable clamp.
3
Digital audio pin cable (supplied)
1 Audio pin cable (supplied)
(White)~~
(White)
(Red)~~(Red)
Audio
2
Optical cable (supplied)
• •
LC=====DD-
Optical cable
CiJ;r
Atla'h 10 Ih;&
"a"
• Information on HDMITM
Audio Signals
Input source Audio signal type
DVD video Dolby Digital, DTS, PCM
DVD audio
2-channel stereo
(up to 96 kHz/24 bit)
Blu-ray Disc
Dolby Digital, DTS, PCM
HDDVD
(Orange)
~~
(Orange)
4 3.5 mm stereo mini plug cable
5
Subwoofer pin cable
Video
o
OSD video pin cable (supplied)
(Yellow)
~~
(Yellow)
• Notes on connecting the optical cable
• Pull out the cap before connecting the optical cable.
When you are not using the optical cable, be sure to put
the cap back in place.
• When inserting the cable into the optical digital jack,
make sure the direction is correct.
~~
Cap
20
En
Notes
• When CPPM copy-protected DVD audio is played back, video
and audio signals may not be output depending on the type of
DVD player.
• This unit is not compatible with HDCP-incompatible HDMI or
DVI components.
:(j{-:.
• We recommend that you use an HOM! cable shorter than 5 m
(16 ft) with the HDMI logo printed on it.
• Use a conversion cable (HDMI jack
~
DVI-D jack) to connect
this unit to other DVI components.
• Priority order for audio input signals
When multiple types of audio signals are simultaneously
being input from a single source component, this unit
plays back the audio signals in the following priority
order:
HDMI
~
Digital
~
Analog
As default settings, the following input jacks are assigned
to the corresponding input sources:
I~
lack
HDMI Digital Analog
Input
source
TV/STB
0
DVD
0 0
AUX I 0 0
AUX2
0
AUX3
0