Advertisement
Available languages
Available languages
Installation
Instructions
[2]STORM WINDOW
REQUIREMENTS
A storm window frame will not allow the air
conditioner to tilt towards the outside and will keep
it from draining properlg. To adjust for this, attach
a piece of wood to the stool.
1/2" higher _
F/W°°d
thanframe f
s\\\
Storm
window
frame
WOOD PIECES
WIDTH: 2"
LENGTH: Long enough to fit inside the window frame.
THICKNESS: To determine the thickness, place a piece
of wood on the stool to make it 1/2" higher than the top
of the storm window frame.
Attach securelg with nails or screws provided bg
the installer.
r3] REMOVE AIR CONDITIONER FROM CASE
[]
Remove the front grille. See the Care and Cleaning
section.
rB] Find the locking plate located on the front
left side.
r_
Remove the screw and the locking plate to unlock
the air conditioner.
II
J Jt /I
Re2°Vw
[]
Remove and discard the shipping screw
on the back of the air conditioner to allow removal
of the air conditioner from the case.
Remove
screw
rE] Pull the bottom corners of the air conditioner
and slide it out of the case.
r_
Remove all shipping pads (if present)inside the air
conditioner next to the compressor.
@
Remove shipping p ads
(ifpresent)
Remove the rear grille that is taped to the back
of the case. Remove the packet of screws taped
to the back of the grille. While holding the grille at a
45 ° angle, insert it into the clips at the top of the case
and push the bottom in. Keep slight upward pressure
on the grille until it fits flush with the bottom of the
case.
If attaching the grille
If attaching the grille
from the outside of the
from the inside of the case,
case, use the 2 long screws,
use the 2 short screws.
Clips
Insert the 2 long screws
onthe outside
// /1111111111111111111111
/
11 /llllllllllllllllllllllllllllllllllllllllllllJ
IJ
II /llllllllllllllllllllllllllllllllllllllllllllJ
II
V
Insert t he 2shortscrews
onthe inside
17
Advertisement
