Fujitsu Eclipse CD 1000 Installation Manual page 10

- Mounting the main unit (If installing the main unit using the mounting sleeve) -
Tip
• • Carefully bind any excess length of wire that is connected to the main unit and secure it to an area of
empty space in the vehicle so that it does not dislodge or interfere with the main unit or vehicle-side
equipment. If the wires are not handled correctly, operating problems or short-circuits may occur, and
this may result in the danger of fire or other accidents.
• • Connect all wires before installing the main unit.
1 Insert the mounting sleeve into the opening in the
vehicle dashboard or console box.
2
Use a screwdriver or a similar tool to bend the
tabs in the mounting sleeve to secure the
mounting sleeve.
3
Mount the stud bolt and bushing to the main unit.
4
Insert the main unit into the mounting sleeve until
it locks in place.
5 Fasten the rear of the main unit.
6 Install the bezel on the main unit.
Tip
• • Be careful not to forcefully push on the main unit's
display or buttons during installation. This may
result in damage to the main unit.
• • This installation method is only one example.
When installing the main unit to the vehicle, be
sure to ask the place of purchase for information
on the installation method used.
- Removing the main unit (If installing the main unit using the mounting sleeve) -
1 Remove the detachable panel.
2 Remove the bezel.
3 Insert the audio unit removal tool on the left and
right side of main unit, and disengage the lock of
the mounting sleeve.
4 Remove the main unit from the mounting sleeve.
Dashboard or
console box
8 Stud bolt
3 Mounting sleeve
Main unit
1
5 Bezel
Detachable panel
Dashboard or
console box
Detachable panel
Dashboard or console box
- 10 -
Metal of vehicle
9 Bushing
Bend the mounting
tabs.
3 Mounting sleeve
5
Bezel
Main unit
1