Chapter 5
Configuring AnyConnect Features Using ASDM
Figure 5-12
In this dialog box, you can set the following attributes:
•
•
Configuring the Dynamic Access Policies Feature of the Security Appliance
On the security appliance, you can configure authorization that addresses the variables of multiple group
membership and endpoint security for VPN connections. There is no specific configuration of
AnyConnect required to use dynamic access policies. For detailed information about configuring
dynamic access policies, see Cisco ASDM User Guide, Cisco Security Appliance Command Line
Configuration Guide, or Cisco Security Appliance Command Reference.
Cisco Secure Desktop Support
Cisco Secure Desktop validates the security of client computers requesting access to your SSL VPN,
helps ensure they remain secure while they are connected, and attempts to remove traces of the session
after they disconnect. The Cisco AnyConnect VPN Client supports the Secure Desktop functions of
OL-12950-012
Enabling or Disabling Dead Peer Detection
Gateway Side Detection—Deselect the Disable check box to specify that dead-peer detection is
performed by the security appliance (gateway). Enter the interval, from 30 to 3600 seconds, with
which the security appliance performs dead-peer detection.
Client Side Detection—Deselect the Disable check box to specify that dead-peer detection is
performed by the client. Enter the interval, from 30 to 3600 seconds, with which the client performs
dead-peer detection.
Configuring, Enabling, and Using Other AnyConnect Features
Cisco AnyConnect VPN Client Administrator Guide
5-15