Epson BrightLink 475Wi Operation Manual page 42

An e-mail notifying the operator of a problem/warning/status is issued
Message
No signal No image signals are being received by the
projector. Check the connection status and check
that the power for the connected equipment is
turned on.
Auto Iris Error Stop using the projector, disconnect the power
cable from the electrical outlet, and contact Epson.
See your User's Guide for more information.
Network error (TCP Check the following items.
connection error)
Check that the projector's power is turned on.
Check that the LAN cable is connected.
Check that Standby Mode is set to Communication
On (or Network On) or Network Monitoring is set to
On in the projector's configuration menu.
See your User's Guide for more information.
Network error Check that the projector has been correctly
(ESC/VP.net connected to the network. See your User's Guide for
communication error) more information.
Network error Check the projector's Monitor Password.
(Monitor Password
authentication error)
* When the projector has 2 lamps, the additional information, such as (Lamp
1) or (Ballast 1), is displayed after the message so that you can know which
lamp has problems/warnings.
Messages to inform that the projector has recovered from the error or
warning statuses are sent.
Remedy
42