Two Post Flush Mount Cabling; Connecting The Cables To The Kvm; Figure 5: Four Post Rack: Routing Power And Data Cables; Figure 6: Removable Portion Of Rail - Dell PowerEdge 180AS Cable Routing Manual

Mounting and Cable Routing Procedures for Dell™ Digital KVM's (1082DS, 2162DS, 4322DS)

Figure 5: Four Post Rack: Routing Power and Data Cables

3.2 Two Post Flush Mount Cabling

Rack Installation Guide
Follow the instructions contained in the to install the KVM flush mount into the
two post rack. Once installed, use these instructions to install the cables. All illustrations in the
following sections were created using the Dell KVM 4322DS.
3.2.1

Connecting the Cables to the KVM

Connect all applicable cables to the rear of the system and verify that all connections are secure. See
Figure 7. Note that the back adjustable portion of the rail has been removed to allow access to the tie
down holes used to retain the cables. See Figure 6 (front and back view of the removable portion of
the rail).

Figure 6: Removable portion of rail

Page 8