Messages For Audio Functions - Pioneer AVIC U310BT - Navigation System With CD player Operation Manual

Appendix

Messages for audio functions

When problems occur in the audio source, a message may appears on the display. Refer to the
table below to identify the problem, then take the suggested corrective action. If the error persists,
contact your dealer or your nearest Pioneer Service Center.
Built-in CD drive
Message
Error-11, 12, 17, 30
Error10, 11, 12, 15, 17, 30, A0,
CHK CDCORE
Error-15
Error-23
Error-22
No Audio
TRK Skipped
Protect
Heat
USB/iPod
Message
No Audio
Protect
TRK Skipped
Check USB
Error-A1
Cause
Dirty
Scratched disc
Electrical or mechanical
The inserted disc does not contain
any data.
The CD format cannot be played
back.
The inserted disc does not contain
any files that can be played back.
The inserted disc does not contain
any files that can be played back.
The inserted disc contains files that
are protected by DRM.
All the files on the inserted disc are
secured by DRM.
The temperature of the navigation
system is outside of the normal op-
erating range.
Cause
The connected USB storage device
does not contain any files that can
be played back.
All the files on the inserted external
storage device are secured by DRM.
The protected files are skipped.
The USB connector or USB cable is
short-circuited.
The connected USB storage device
consumes more than 500 mA (maxi-
mum allowable current).
The connected USB storage device
consumes more than 500 mA (maxi-
mum allowable current).
Action (Reference)
Clean the disc.
Replace the disc.
Turn the ignition switch OFF and back ON, or
switch to a different source, then back to the
CD player.
Replace the disc.
Replace the disc.
Replace the disc.
Replace the disc.
Replace the disc.
Replace the disc.
Wait until the unit's temperature returns to
within normal operating limits.
Action (Reference)
Store playable files.
Store playable files.
Store playable files.
Confirm that the USB connector or USB
cable is not caught in something or da-
maged.
Disconnect the USB storage device and do
not use it. Turn the ignition switch to OFF,
then to ACC or ON and then connect the
compliant USB storage device.
Disconnect the USB storage device and do
not use it. Turn the ignition switch to OFF,
then to ACC or ON and then connect the
compliant USB storage device.
Appendix
117
En