Level Dryer - Kenmore 6965 - 600 5.9 cu. Ft. Capacity Electric Flatback Dryer Installation Instructions Manual

10. Remove door strike plug (B). Insert the door strike you
removed in Step 8 into hole and secure with screw. Insert
door strike plug into original door strike hole and secure
with screw.
11. Close door and check that door strike aligns with door catch
(C). If it is needed, slide door catch left or right within slot to
adjust alignment.
1. Check that all parts are now installed. If there is an extra
part, go back through the steps to see what was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. Check dryer's final location. Be sure vent is not crushed
or kinked.
5. Check that dryer is level. See "Level Dryer."
6. For power supply cord installation, plug into an outlet. For
direct wire installation, reconnect power.
7. Remove film on the console and any tape remaining on dryer.
8. Read "Dryer Use."
g.
10.
Wipe dryer drum interior thoroughly with a damp cloth to
remove any dust.
Select a Timed Dry heated cycle, and start the dryer. Do
not select the Air Only Temperature setting.
If the dryer will not start, check the following:
• Controls are set in a running or "On" position.
• The Start button has been pushed firmly.
• Dryer is plugged into an outlet and/or electrical supply
is connected.
• Household fuse is intact and tight, or circuit breaker has
not tripped.
• Dryer door is closed.
This dryer automatically runs an installation diagnostic routine
at the start of its first cycle.
If you receive an L2 code, there may be a problem with your
home power supply keeping the dryer's heater from turning
on. See "Troubleshooting."
If you receive an AF code, your dryer vent may be crushed
or blocked. See "Troubleshooting."
NOTE: You may notice an odor when the dryer is first heated.
This odor is common when the heating element is first used.
The odor will go away.
15