Gas Connection; General Installation; Replacement Parts - Kenmore 8804 - 5.8 cu. Ft. Electric Dryer Installation Instructions Manual

GAS CONNECTION
1. Remove the shipping cap from gas pipe at the rear of the
dryer.
NOTE: DO NOTconnect the dryer to L.R gas service without
corwerting the gas valve. An LR conversion kit must be installed
by a qualified gas technician.
2. Connect a I/2 inch (1.27 cm) I.D. semi-rigid or approved
pipe from gas supply line to the 3/8 inch (0.96 cm) pipe
located on the back of the dryer (see pages 6 and 7). Use a
1/2 inch to 3/8 inch (1.27 cm to 0.96 cm) reducer for a
connection. Apply an approved thread sealer that is resistant
to the corrosive action of liquefied gases on all pipe
connections.
3. Open the shutoff valve in the gas supply line to allow gas to
flowthrough pipe.
4. Testall connections by brushing on a soapy water solution.
VALVE OPEN I
GAS FLOW POSITION
NEVER test for gas leaks with an open flame.
GENERAL INSTALLATION
I. Connect the exhaust duct to outside exhaust system (see
pages 3 and 4). Use duct tape to seal all joints.
2. With the dryer in its final position, adjust one or more of the
legs until the dryer is resting solid on all four legs. Place a
level on top of the dryer. The dryer MUST be level and
resting solid on all four legs.
3. Plug the power cord into a grounded outlet. NOTE: Check
to ensure the power is off at circuit breakedfuse box before
plugging the power cord into the outlet.
4. Turn on the power at the circuit breaker/fuse box.
Before operating the dryer, make sure the
dryer area is clear and free from combustible materials,
gasoline, and other flammable vapors. Also see that
nothing (such as boxes, clothing, etc.) obstructs the flow
of combustion and ventilation air.
7. Place these instructions in a location near the dryer
for future reference.
NOTE: Awiring diagram is located inside the dryer console or
under the top panel.
REPLACEMENT PARTS
Pedestal
A pedestal accessory,ModelNo. 48062 (white), 48066(black),
specifically designed for this dryer may be used when elevating
the dryer for ease of use. Failure to use accessories certified by
the manufacturer could result in personal injury, property damage
or damage to the dryer.
If replacement parts are needed for your dryer, call
Sears Parts and Service Toll Free Number
1-800-366-PART(1-800-366-7278).
Label all wires prior to disconnection when servicing
controls. Wiring errors can cause improper and dangerous
operation. Verify proper operation after servicing.
Destroy the carton and plastic bags after the dryer
is unpacked. Children might use them for play. Cartons covered
with rugs, bedspreads, or plastic sheets can become airtight
chambers causing suffocation. Place all materials in a garbage
container or make materials inaccessible to children.
The instructions in this manual and all other
literature included with this dryer are not meant to cover every
possible condition and situation that may occur. Good safe
practice and caution MUSTbe applied when installing, operating
and maintaining any appliance.
5. Run the dryer through a cycle check for proper operation.
NOTE: On gas dryers, before the burner will light, it is
necessary for the gas line to be bled of air. If the burner does
not light within 45 seconds the first time the dryer is turned on,
the safety switch will shut the burner off. If this happens, turn
the timer to "OFF" and wait 5 minutes before making another
attempt to light.
6. If your dryer does not operate, please review the "Avoid
Service Checklist" located in your Use and Care Guide be-
fore calling for service.
12