Power Cord Connection - GE WSM2700WWW - 27" Unitized Spacemaker Washer Installation Instructions Manual

UNPACKING SPACEMAKER
1
Remove tape and two corner pads from rear
bottom corners of appliance.
2
Using the four shipping corner posts, lay the
appliance on its left side so the shipping base does
not rest on the floor.
Shipping
blocks
Plastic spacer
block
Mechanism
shipping bolt
Foam
shipping pad
3
Remove the foam shipping pad.
4
Remove the washer shipping bolt using the ratchet
with 3/8" socket and remove the plastic spacer
block using the slip-joint pliers.
5
Return the appliance to the upright position
and locate it in the general area to be installed.
Provide enough space at the rear for installing
the water inlet hose.
6
Untape and open the washer lid.
7
Remove:
a. foam tub blocking pad
b. foam shipping blocks from rear of unit
c. tape from dryer door
d. foam dryer support pads
e. inlet hoses
f. From the back of the washer, remove only
the WIRE shipping clips that secure the drain
hose to the left side of the washer backsheet.
DO NOT REMOVE THE PLASTIC CLAMPS on the
right side of the washer. These clamps form
a standpipe to prevent water siphoning.
Dryer
support pads
Installation Instructions
™
Shipping
Rear vent
clips
only
Drain hose
Shipping carton
corner posts
Tub
blocking pad
UNPACKING SPACEMAKER
NOTE: The tub blocking pad, shipping bolt and plastic
spacer should be retained for use if the appliance
is transported at a later date.
8
Form a "U" shape on the end of the drain hose with
hose pointed toward the drain. For an installation
requiring a longer drain hose, use WH41X0387
(approximately 112"). This drain hose attaches
directly to the pump and should be installed by
a qualified technician.
INLET HOSE CONNECTIONS
9
Remove the inlet hoses and rubber washers from
the plastic bag.
9A
Install the rubber washers in each end of the inlet
hoses.
9B
Carefully connect the inlet hose marked "HOT"
to the bottom outlet of the water valve. Tighten
by hand; then tighten another 2/3 turn with pliers.
Carefully connect the other inlet hose to the top
outlet of the water valve. Tighten by hand; then
tighten another 2/3 turn with pliers.

POWER CORD CONNECTION

SEE ELECTRICAL CONNECTION INFORMATION
2
(CONT.)
™