Advertisement
Available languages
Available languages
Quick Links
Download this manual
See also:
Use and Care Manual
INSTALLATION
AND SERVICE MUST BE PERFORMED BY
A QUALIFIED
INSTALLER.
IMPORTANT:
SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE.
28 1/8"
(71,4cm)
_i
with
handleJ
J
I
1
24"
Min.
(61 cm Min.)
Grounded
24 1/2"
max.
Wall Outlet
(62.2 cm Max.)
D
Do not pinch the power supply cord between the range
and the wall.
Do not seal the range to the side cabinets.
**NOTE: 24" (61 cm) minimum clearance between the
cooktop and the bottom of the cabinet when the bottom
of wood or metal cabinet is protected by not less than
1/4" (0.64 cm) flame retardant millboard covered with
not less than No. 28 MSG sheet metal, 0.015" (0.4 ram)
stainless steel, 0.024" (0.6 ram) aluminum, or 0.020"
(0.5 mm) copper.
30" (76.2 cm) minimum clearance when the cabinet is
unprotected.
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii+_+_+:
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_+i+_
' +i+i+i+i+i+i+i+i+i+i+i+i+i+i+i+i+i+i+i+i+i+i+i+i+i+iii_!+i_'ili
+_i_i_ii_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_!i_!_JJ+
i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!!i_+!_!_+!_+!!_!_!_+!_3_+_+_i+_
_i_+_+_iiiiiiiiiiiiiiiiiiiiiiiii++iii_i_i_
48 1/8"(122.24cm)
40 1/8"(101.9cm)
25 1/2"(64.8cm)
43 3/4"(111.1cm)
40 1/4"(102.2cm)
36"(91.4cm) standard
35 3/8" (90 cm) min.
P/N 318201702 (0301) Rev.A
English - pages 1 - 8
Espa_ol - p_iginas 9 - 16
Advertisement
Related Manuals for Kenmore 9961 - Elite 40 in. Electric
Summary of Contents for Kenmore 9961 - Elite 40 in. Electric
- Page 1 INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. 28 1/8" (71,4cm) with handleJ 24" Min. (61 cm Min.) Grounded 24 1/2" max. Wall Outlet (62.2 cm Max.) Do not pinch the power supply cord between the range **NOTE: 24"...
-
Page 2: Important Safety Instructions
• Make sure the wall coverings around the range Important Notes to the Installer can withstand the heat generated by the range. Read all instructions contained in these installation • Before installing the range in an area covered instructions before installing range. with linoleum or any other synthetic floor... - Page 3 Power Supply Cord Kit Electrical Connection to the Range The user is responsible for connecting the power supply This appliance is manufactured with the neutral terminal cord to the connection block located behind the back connected to the range. panel access cover.
- Page 4 2. Remove t he 3 loose nuts(afteryouremoved t he Four Conductor Wire Connection to Range rubber band) ontheterminal b lockusing 3/8" nut (mobile homes) driveror socket. 1. Remove the 3 screws at the lower end of the rear wire Connect the neutral white wire of the copper power cover, then raise the lower end of the rear wire cover supply cord to the center silver-colored terminal of the (access cover) upward to expose range terminal...
- Page 5 Direct Electrical Connection to the Circuit Where local codes DO NOT permit connecting appliance grounding conductor to the neutral Breaker, Fuse Box or Junction (white) wire or if connecting to 4-wire electrical If the appliance is connected directly to the circuit breaker, system (see Figure 6).
- Page 6 Junction Box Location the cabinet. If back of range will not be flush with the wall (the location of the outlet may not allow the Locate junction box as shown in Figure 7. range to be positioned against the wall), draw a line on If a service cord is used, the wall receptacle should be the floor where the back edge of the range will be.
- Page 7 5. Install 4 shipping boltsasleveling legs. Operation of Oven Elements 6. Laya large piece of cardboard i n frontof the range. The oven is equipped with an electronic oven control. Each of the functions has been factory checked before shipping. Carefully stand the range upright on cardboard.
- Page 8 Unfold paper template and place it flat on the floor Important Safety Warning with the back and side edges positioned exactly To reduce the risk of tipping of the range, the range where the back and sides of range will be located must be secured to the floor by properly installed anti-tip when installed.
- Page 9 LA INSTALACION Y EL SERVICIO DEBEN SER EFECTUADOS POR UN INSTALADOR CALIFICADO. IMPORTANTE: GUARDE ESTAS INSTRUCCIONES PARA USO DEL INSPECTOR LOCAL DE ELECTRICIDAD. LEA Y GUARDE ESTAS INSTRUCCIONES PARA REFERENCIA FUTURA. 28 1/8" 40 1/8" Min. (71,4cm) (101.9 cm) con tirador/ 2 t/2"...
- Page 10 • Asegt_rese de que el material que recubre Notas importantes para el Instalador paredes alrededor de la estufa, pueda resistir Lea todas las instrucciones contenidas en este manual calor generado la estufa. antes de instalar la estufa. • Antes de instalar la estufa en un _rea cuyo piso...
- Page 11 ueo e o Juego de Cordon EI6ctrico El consumidor tiene la responsabilidad de conectar cordon electrico al bloque de conexiOn ubicado detr_qs de Receptaculo la cubierta de acceso del panel trasero. Pared de 3 Alambres Este artefacto puede set conectado mediante "cableado de Suministro...
- Page 12 Conexion de 4 alambres de conduccion a la 1. Quite los tres tornillos en la parte m_qs baja del panel trasero, luego levante la parte m_is baja del panel estufa (casas moviles) trasero (la cubierta de acceso) exponiendo el bloque 1.
- Page 13 Donde los codigos locales NO permitan conectar Conexion electrica directa al cortacircuito, conductor de puesta a tierra del electrodomestico la caja de fusibles o la caja de empalmes neutral (blanco), o si est_ conectado con un sistema Si el aparato esta conectado directamente al cortacircuito, 4 alambres...
- Page 14 Si la estufa se va a instalar con un armario a solo un Situacion de caja de union lado, mueva la estufa a su posici6n final. Marque el piso Localice la caja de empalmes como se ve en la por el lado de la estufa que no estar_q contra el armario. Figura Si la parte trasera...
- Page 15 Funcionamiento de los Elementos del Horno 2. Tome las 4 esquinas de cart6n de la caja de empaque. Col6quelas una encima de otra. Repita esta operaci6n El homo esta equipado con un control electr6nico. Cada con las otras 2 esquinas. Coloque las esquinas funci6n ha sido probada...
- Page 16 Desdoble la plantilla de papel y col6quela plana en Importante Advertencia de Seguridad el piso con los bordes laterales y el trasero colocados Para reducir el riesgo de que la estufa se vuelque, exactamente donde la parte trasera y los lados de la necesario asegurarla al piso instalando los soportes...