Basic; Preparation; Examples Of Simple Option Output; On & Off Operation Synchronizing With One Machine Operation - Brother BAS-311E Option Manual

Basic

1. Preparation

Sewing machine with the pneumatic work clamp (except for BAS-311E solenoid specification)
Control PROM version MN-C or later (products manufactured in or after June 1998 are equipped
with this PROM as a standard part.)
Programmer
Instruction manual for programmer (see the instruction manual for page reference.)

2. Examples of simple option output

Option output can be programmed up to No. 16 (see page 195). No. 15 is the air valve output for the
left work clamp, and No.16 is the air valve output for the right work clamp. If these two outputs are
programmed as option outputs, these do not operate as the work clamps but operate as the option
outputs.
The following example operations are to program No. 15 and 16 and check their operations (if the
right and left work clamps operate as programmed, the operations of No. 15 & 16 are good).
Some of the following examples involve sewing operation with the work clamp raised, be extremely
careful in that case.
2-1 ON & OFF operation synchronizing with one machine operation
Create program that enables the right and left work clamps automatically to rise and descend
(option output No. 15 is ON and OFF) at sewing start.
•Prepare the programmer, follow "Operating the extended option output" (see page 184) to display
the output setting screen.
‚Referring to the condition number table of machine operation mode (see page 191), set the option
output No. 15 to ON when the condition No. 2 is set, and the timer 2 to 1 second (1000ms). Input on
the setting screen as follows:
Press the RETURN key to save the data after inputting the numerical data.
For input check, move the cursor to OUPTPUT No., set it to No. 16 by pressing the + key once, and
set it back to No. 15 by pressing the
ƒPress the ESC key, and write the data with the FD write icon.
key.
3