Specifications; Applications; Prior To Operation - Hitachi EC25E - Lon Wheelbarrow Air Compressor Instruction Manual

English

SPECIFICATIONS

Compressor Model
Engine Manufacturer And Model
Displacement
Max. Output
Fuel Tank Capacity
Tank Capacity
Maximum Pressure
at 40 PSI
Free Air Delivery
(2.8 bar)
at 90 PSI
(6.2 bar)
at 100 PSI
(6.9 bar)

APPLICATIONS

Air source of the pneumatic nailer and stapler.

PRIOR TO OPERATION

1. Initial set-up
A) Read safety warnings before setting-up this
compressor.
B) Ensure the oil level in this compressor pump is
adequate. If the oil level is low, replenish oil through the
filling hole so that the amount of oil will come to a point
between the maximum notch and the minimum notch
on the dipstick according to the following OIL TYPE
CHART. (Fig. 2)
OIL TYPE CHART
Ambient
14~32
temperature
(°F)
(°F)
Non-detergent
SAE 10W
oil
2. Location
A) In order to avoid damaging this compressor, do not
incline this compressor transversely or longitudinally
more than 10°.
B) Place this compressor at least 12 inches away from
obstacles that may prevent proper ventilation. Do not
place this compressor in an area:
- where there is evidence of oil or gas leaks.
- where flammable gas vapors or materials may be
present.
- where air temperatures fall below 14°F or exceed
104°F.
- where extremely dirty air or water could be drawn
into this compressor.
32~68
68~104
(°F)
(°F)
SAE 20W SAE 30
-
Honda GX160
9.9 cu in (163 mL)
5.4bhp (4.0kW, 5.5PS)/3600min
0.95 US gal. (3.6 L)
8.0 gal. (30.3L)
125 PSI (8.6 bar)
10.6 CFM (300 L/min)
9.6 CFM (272 L/min)
9.0 CFM (255 L/min)
3. Gasoline engine
A) Review page 5.25 before fueling.
WARNING Do not allow the engine or muffler to come
in contact with flammable vapors,
combustible dust, gases or other
combustible materials. A spark may cause
a fire.
Do not place this compressor in an area
where flammable gas vapors may be
present. A spark can cause an explosion
or fire.
B) Read the engine manual accompanying this
compressor for correct engine start-up maintenance
procedures.
C) Read and understand the safety labels located on
this compressor.
D) A minimum of 85 octane fuel is recommended for
use with this compressor. Do not mix oil with
gasoline.
E) Use of clean, fresh, lead free gasoline should be
used. Do not use gasoline containing methanol or
alcohol.
F) Check the engine oil level before starting. (See
engine manual.)
G) Fill the fuel tank according to the engine manual
instruction.
-
8
EC25E
-1