Table of Contents
Advertisement
Rear panel
1. Audio output
This connector is for an analog audio output cable. This connector is
compatible with "Molex 70553".
Pin
1
2 & 3
4
2. Device configuration jumper
These pins allow you to select either Master, Slave, or Cable Select
mode for the drive. ( Refer to page 14 for the jumper settings )
Pin
1
2
3
4-5
3. Air vent
This air vent allows air intake to maintain ideal drive temperature.
Make sure the air vent is not blocked by cables or other objects inside
the system.
4. Host IDE interface
This connector is for a 40-pin IDE cable to connect the drive to the IDE
interface on the motherboard.
5. DC input
This DC connector is for a 4-pin power cable from the system power
supply.
12
1
2
Name
Description
L
Left channel audio output
G
Ground
R
Right channel audio output
Name
Switch Status
MA
ON
SL
ON
CS
ON
ASUS DRW-0804P DVD
3
4
Description
Master mode
Slave mode
Cable select mode
Reserved
5
±
R/RW drive
Advertisement
Table of Contents
