Initial Installation - Toshiba 32BV702B Owner's Manual

Before switching on the television put your decoder and media recorder to Standby if they are connected
and ensure the aerial is connected to your television. To set up the television use the buttons on the remote
MPORTANT: Ensure that the aerial is connected and
a Common Interface module is not inserted before
switching on the TV for the fi rst time installation.
1. Connect the mains plug and switch the TV to on
using the . If the TV does not switch on,
button
press any numbered or
control, then the language selection menu will
be displayed. This screen will appear the fi rst
time that the TV is switched on and each time
the TV is reset.
2. By pressing Up or Down button, highlight the
language you want to set and press OK button.
The following message will be displayed next:
3. By pressing Left or Right button, select the
country you want to set and press Down button
to highlight the Search Type option. Use Left or
Right to set the desired search type. Available
search types are Digital and analog, digital only
and analog only.
4. When set, Down buton to select Teletext
Language. Use Left or Right button to select
desired Teletext Language.
5. Press Down button after setting Teletext Language
option. Scan Encrypted will be then highlighted.
You can set Scan Encrypted as Yes if you want
to scan coded stations.
32BV702B_MB62_[GB]_(IB_INTERNET)_DVB-T_(3910UK)_10075897.indd 19 32BV702B_MB62_[GB]_(IB_INTERNET)_DVB-T_(3910UK)_10075897.indd 19

Initial Installation

control as detailed on page 13.
6.
button on the remote
7.
8.
Note: You can press MENU button to cancel.
• After the available stations are stored, Channel List
will be displayed on the screen. If you like the sort
channels, according to the LCN, please select Yes
and then press OK button (if available).
• Press
Note: Do not turn off the TV while initializing fi rst time
installation.
- 19 -
Press OK button on the remote control to continue
and the following message will be displayed on
the screen:
Select Yes button by using Left or Right button
and press OK button to continue.
The Auto tuning screen will appear and the
television will start to search for available stations.
The progress bar will move along the line. You
must allow the television to complete the search.
The following OSD will be displayed on the screen
and the television will search for the selected
broadcasts:
OK button to quit channel list and watch TV.
21.01.2012 17:54:49 21.01.2012 17:54:49