Gl2: W0502 The Parameter Is Out Of Range; Gl2: W0504 This Command Is Not Supported; There Is No Data - Canon imagePROGRAF iPF610 User Manual

Messages regarding HP-GL/2
This type of paper is not compatible with HP-GL/2.
The printer has received a HP-GL/2 print job that
cannot be printed on the paper that has been
advanced.
GL2: Wxxxx The memory is full. (xxxx is 0501, 0903, or
0904)
The printer memory is full.

GL2: W0502 The parameter is out of range.

A parameter specied in a HP-GL/2 command is out
of the supported range.

GL2: W0504 This command is not supported.

The printer has received an unsupported HP-GL/2
command.

There is no data.

The data was lost because of replotting.
Cause
Cause
Cause
Cause
Cause
Corrective Action
Replace the paper with a type compatible with
HP-GL/2. For details on paper compatible with
HP-GL/2, refer to the Paper Reference Guide.
(→P.112)
The printer may continue printing, but the printing
quality may be affected. Check the printing results.
Corrective Action
Because the entire print job could not be received,
the printer may not be able to print the entire original.
Check the printing results.
Corrective Action
Check the print job.
Corrective Action
Check the print job.
Corrective Action
Data for replotting is lost after the following
operations. In this case, send the print job again.
•
The memory buffer was cleared from the Control
Panel.
•
The printer was turned off.
•
The printer received a new print job.
Messages regarding HP-GL/2
Error Message 717