Table of Contents
Advertisement
Energy saver and energy save mode
Introduction
Turning on the energy saver (LED lights) enters the energy save mode and cuts electric
power in order to melt glue and adjust temperature. Use the energy saver when you want
to keep only the functions that transport paper (pass-through transfer) to the next device
operational, without performing binding.
The energy save mode also is entered automatically for the amount of time set from the
settings editor, when a prescribed amount of time has passed following completion of a
booklet, etc. To recover from the energy save mode, press the energy saver.
The time for entering the energy save mode following completion of a booklet can be set
from the settings editor.
Adjust the time for entering the energy save mode from the settings editor. Consult the
manual that comes with the printer for the procedure.
The energy saver LED indicates the following.
•
Lit: Glue temperature adjustment is not being done, the binder is in energy save mode.
•
Flashing: Glue temperature is being adjusted to the correct binding temperature.
•
Off: Binding is possible, the glue is at the correct temperature for binding.
Energy save mode
Press the energy saver to enter the energy save mode.
1.
The energy save LED will light and glue temperature adjustment will stop.
To recover from the energy save mode, press the energy saver again.
2.
The energy save LED will flash and then go out, indicating binding can now be done.
#
NOTE
When you do binding settings on the printer, the Perfect Binder-B1 automatically
recovers from the energy save mode.
Energy saver and energy save mode
Chapter 2 - Before you start using this machine
35
Advertisement
Table of Contents
