Table of Contents
Advertisement
Measuring the chart and updating the profile
Follow these steps to complete the profile modification process:
1. Place the printout of the standard color chart you received
from your printing vendor on a flat surface with the included
black base paper behind it.
2. Select an empty block in the EPSON Profile Updater dialog
box by clicking
corresponding block of the color chart.
Note:
Make sure the sensor tip is placed flat and firmly on the paper.
3. Click the Calibration button, or press the measure button at
the top of the calibrator to measure the color.
Note:
Do not measure the sample chart under strong light or direct
sunlight as this could render the measurement inaccurate.
4. Repeat steps 2 and 3 until every block of the color chart is
measured, then click the Done button, or click Save File.
Note:
You can't save the file until you measure every block.
5. Type a name for the new file in the File Name box and click
Save.
4-4
Calibrating Your System to Another
it.
Place the sensor tip of the calibrator on the
Advertisement
Table of Contents
