Installing CD Audio Player For Windows
If "CD Audio" is not available in your Windows Accessories Group "Media Player", you must complete the following steps to
install it:
Go to "Control Panel" and then to "Drivers";
1)
If [MCI] CD Audio is not listed go to add;
2)
Chose [MCI] CD Audio and install the file;
3)
If [MCI] CD Audio was listed choose setup and your CD-ROM should be detected;
4)
Exit Windows and then restart Windows;
5)
Go to Media Player and choose CD Audio under device.
6)
Installing OS/2 2.x and 3.x
If you are using OS/2 Warp, you must choose the driver "Unlisted IDE CD-ROM";
1)
If you are using OS/2 2.x, you must obtain the new drivers from Epson or IBM.
2)
Installing Linux
You must obtain the IDE compatible files from your Linux distributor or from Epson
Installing A IDE Controller Card With A Primary and Secondary Port
If you are connecting the Epson CD-ROM to the secondary port of the controller card, the drive must be configured to be a
master drive. When you are using the master drive configuration, it is suggested that you also use IRQ 15.
ATA/IDE Owner's Manual
Additional Installation Instructions
15