Connecting The Pcmcia Controller Card - Epson DYO-211/212 (FDD User Manual

Connecting the PCMCIA Controller Card

Follow these steps to connect the PCMCIA ribbon cable to the
PCMCIA controller card.
1. Locate the twin connector sockets on the DYO 211 or 212
PCMCIA controller card, as shown below.
2. Position the PCMCIA ribbon cable connectors so that the
small tab in the middle of each connector aligns with the
middle notch in each connector socket, as shown above.
Then push in the cable connectors. If necessary, support the
controller card with one hand as you push the connectors
in with the other.
3. Replace the computer's cover as described in your computer
manual, and reconnect the power cord to your computer.
4. See the next section to configure the diskette drive and the
PCMCIA drive.
12