Mounting The Mcx-C15 And Mcx-Ca15 In A Wall - Yamaha MCX-C15 - MusicCAST Network Audio Player Install Manual

MAKING IN-WALL CONNECTIONS
To connect CAT-5 cables
Use these connections to:
• Transfer AV signals between the MCX-C15 and
MCX-CA15 (or I/O box) using the supplied
CAT-5 cable (straight).
• Transfer network signals between the MCX-C15
and the server using a commercially available
CAT-5 cable (straight).
MCX-C15
LAN
MCX-C15
MENU
VOL
1 2 3 4
FAVORITES
AV OUT
AV IN
MCX-CA15
MCX-CA15
AUDIO OUT SW OUT
AUDIO IN IR/CTRL VIDEO OUT
or
DC IN 12V
I/O box
STATUS
(MCX-IB15)
CAUTIONS
• Complete these connections before
connecting to a live power source.
• Do not connect the MCX-C15 directly to
the server using a CAT-5 cable.
Insert the end of the CAT-5 cable (straight)
into an AV OUT, AV IN or LAN terminal.
Note
When connecting the MCX-C15 to a hub or router
connected to a network, make sure the DHCP server
function is enabled on the server (default setting).
For details, see the MCX-1000 Owner's Manual,
page 110. Further, make sure the MCX-C15 settings
are set to the factory default.
12
Both the MCX-C15 and MCX-CA15 are designed
for wall-mounted installation using a commercially
available low-voltage double gang mounting
bracket. Use the following procedure to install either
or both of these units in a wall.
•
Hub or router
•
Server
•
•
1
Mounting the MCX-C15 and
MCX-CA15 in a wall
CAUTIONS
Be sure to leave 10 cm (3-15/16") of
ventilation space to the top, bottom, left
and right of these units, and remove all
insulating materials, etc. If a support
beam prevents adequate clearance
around these units, make sure that
sufficient space is cleared on the
opposite side of the support beam.
When inserting these units, make sure
no cables are jammed between the unit
and the opposite wall.
Complete all in-wall connections before
connecting to a live power source.
Do not install these units upside-down.
Doing so may cause them to overheat,
resulting in electrical shock, fire or
damage to the unit.
Make a hole in the wall big enough to fit
the low-voltage double gang mounting
bracket you are using.