Configuring A Host Statically To Join A Group - Cisco 2950G 24 - Catalyst Switch Software Configuration Manual
Desktop switch
Hide thumbs
Also See for 2950G 24 - Catalyst Switch:
- Migration manual (25 pages) ,
- Datasheet (19 pages) ,
- Product support bulletin (5 pages)
Table of Contents
Advertisement
Configuring IGMP Snooping
Command
Step 3
end
Step 4
show ip igmp snooping mrouter [vlan vlan-id] Verify that IGMP snooping is enabled on the VLAN interface.
Step 5
copy running-config startup-config
To remove a multicast router port from the VLAN, use the no ip igmp snooping vlan vlan-id mrouter
interface interface-id global configuration command.
This example shows how to enable a static connection to a multicast router and verify the configuration:
Switch# configure terminal
Switch(config)# ip igmp snooping vlan 200 mrouter interface gigabitethernet0/2
Switch(config)# end
Switch# show ip igmp snooping mrouter vlan 200
vlan
-----+----------------------------------------
200
Configuring a Host Statically to Join a Group
Hosts or Layer 2 ports normally join multicast groups dynamically, but you can also statically configure
a host on an interface.
Beginning in privileged EXEC mode, follow these steps to add a Layer 2 port as a member of a multicast
group:
Command
Step 1
configure terminal
Step 2
ip igmp snooping vlan vlan-id static
mac-address interface interface-id
Step 3
end
Step 4
show ip igmp snooping mrouter vlan vlan-id
or
show mac address-table multicast vlan vlan-id
Step 5
copy running-config startup-config
To remove the Layer 2 port from the multicast group, use the no ip igmp snooping vlan vlan-id static
mac-address interface interface-id global configuration command.
Catalyst 2950 Desktop Switch Software Configuration Guide
17-8
Purpose
Return to privileged EXEC mode.
(Optional) Save your entries in the configuration file.
ports
Gi0/2(static)
Purpose
Enter global configuration mode
Statically configure a Layer 2 port as a member of a multicast
group:
•
vlan-id is the multicast group VLAN ID.
•
mac-address is the group MAC address.
•
interface-id is the member port.
Return to privileged EXEC mode.
Verify that the member port is a member of the VLAN multicast
group.
Verify the member port and the MAC address
(Optional) Save your entries in the configuration file.
Chapter 17
Configuring IGMP Snooping and MVR
78-14982-01
Advertisement
Table of Contents
Troubleshooting
