PRS-650
2-3.
CASE (REAR) BLOCK
2-4.
BATTERY ASSY (BAT1)
Note 1: Exchange it for an absolutely new part when you remove the BATTERY ASSY (BAT1) built into this set.
wire of battery
assy (BAT1)
MAIN board
frame (rear) assy
Note 2: When installing the battery assy (BAT1), make the
sheet (BATT) slip into the frame (rear) assy under.
sheet (BATT)
frame (rear) assy
4
2
1 Turn over the sheet (BATT).
3 ten claws
4 case (rear) block
– Rear side view –
3 Pull this part of sheet (BATT) and lift the battery assy.
4 battery assy (BAT1)
1 two shaft screws
2 battery connector
(CN103)
–
–