Advertisement
Available languages
Available languages
Filter Replacement and Care
CAUTION:
To help retard bacteria
growth and keep maximum
efficiency,
the filter should
be
replaced
at least once per season,
or more often under hard water
conditions,
Use Kenmore
15508
replacement
filter.
WARNING:
To reduce
the risk of
shock or injury from moving parts,
always
unplug humidifier
before
removing
or replacing
any parts,
Replace
the evaporative
wicking
filter
at least once per humidification
season
or more depending
on water conditions
in your area_
Filter
Replacement
1. Unplug
humidifier.
Before
removing
the filter, move the humidifier
to an
area not susceptible
to water damage.
(i e, kitchen
or bath areas).
2. Remove
the water bottle and set
aside° Be sure not to bump or damage
the fill valve,
3o The upper housing
and the base are
held together
by two hooks at the front
of the housing
and a flexible snap in
the rear, To remove
the housing,
press
in on the triangular
shaped
snap at the
rear of the humidifier,
below the cord
exit, while lifting upward, tilting the
upper housing
forward
to clear the
hooks at the front of the base.
4. Set the upper housing
aside.
The filter is now accessible.
5, Take note of the filter position.
Remove
the filter. You may want
to clean the base at this time
See
the "Cleaning
and Maintenance"
section
of this manual
6, Install a new filter (15508)
into
the base, Position
the filter
between
the uprights
in the bottom
of the base. The filter should
be
resting
on the floor of the base.
7. Return the upper housing
to the
base by first placing
the hooks
located
near the front of the base
into the mating
holes in the upper
housing,
Then tilt the upper
housing
down towards
the base
until the rear snap engages
the
main housing
8, Reposition
the humidifier
to its
operating
position,
9, The humidifier
is now ready to
be filled for operation.
10
Advertisement
