Sharp LC-26DV20U - 26" LCD TV Operation Manual page 55

Appendix
Before detaching (or attaching) stand, unplug the AC cord from the AC INPUT terminal.
• Do not remove the stand from the TV/DVD unless using an optional wall mount bracket to mount it.
Before attachingldetaching stand
* Before performing work make sure to turn off the TV/DVD.
* Before performing work spread cushioning over the base area to lay the TV/DVD on. This will prevent it from
being damaged.
r
1
t"_ hex key
2
Soft cushion
Unfasten the four screws used to secure the stand in
place.
Detach the stand from the TV/DVD.
(Hold the stand so it will not drop from the edge of the
base area.)
• To attach the stand, perform the above steps in reverse order.
• Installing the TV/DVD requires special skill that should only be performed by qualified service personnel. Customers
should not attempt to do the work themselves, SHARP bears no responsibility for improper mounting or mounting
that results in accident or injury.
Using an optional bracket to mount the TV/DVD
• You can ask a qualified service professional about using an optional AN-26AG1 bracket to mount the TV/DVD
to the wall,
• Carefully read the instructions that come with the bracket before beginning work,
Hanging on the wall About setting the TV/DVD angle
Wall mount bracket. (See the bracket instructions for details.)
Vertical mounting
Angular mounting
Angle of TV/DVD : up to 20 °
I
DETACH THE CABLE CLAMP ON THE REAR OF THE TV/DVD WHEN USING THE OPTIONAL MOUNT BRACKET.
(_= 55