Sdv Abort Vsan - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

sdv abort vsan

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
sdv abort vsan
To terminate an SDV configuration for a specified VSAN, use the sdv abort vsan command in
configuration mode.
Syntax Description vsan-id
Defaults Disabled.
Command Modes
Configuration mode.
Command History Release
3.1(2)
Usage Guidelines To use this command, you must enable SDV using the sdv enable command.
Examples The following example shows how to terminate an SDV configuration for a specified VSAN.
switch# config t
Enter configuration commands, one per line.
switch(config)# sdv abort vsan 2
Related Commands Command
show sdv database
sdv enable
Cisco MDS 9000 Family Command Reference
21-16
sdv abort vsan vsan-id
Specifies the number of the VSAN. The range is 1 to 4093.
Modification
This command was introduced.
Description
Displays the SDV database.
Enables SDV.
End with CNTL/Z.
OL-18089-01, Cisco MDS NX-OS Release 4.x
Chapter 21 S Commands