Related Manuals for Philips SBA3210/37
Summary of Contents for Philips SBA3210/37
-
Page 1: User Manual
Register your product and get support at www.philips.com/welcome SBA3210/37 User manual... -
Page 2: Important Safety Instructions
Important Safety Important Safety Instructions Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. - Page 3 Never place this apparatus on other electrical equipment. Notice Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is...
-
Page 4: Disposal Of Your Old Product
The correct disposal of batteries helps prevent potentially negative consequences on the environment and human health. Please visit www.recycle.philips.com for additional information on a recycling center in your area. Always bring your product to a professional to remove the built-in battery. -
Page 5: Get Started
Get started Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. Write the numbers here: Model No. - Page 6 • The power indicator turns off when it’s fully charged. Play 1 Connect your two speakers with supplied cable. 2 Connect your device to the speaker. 3 Slide the switch to turn the speaker on. » The power indicator turns on. 4 Adjust the volume and navigate your audio content on your device.
-
Page 7: Product Information
Product information Note • Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power 2 x 2W RMS Signal to Noise Ratio >70dB Aux-in Link 600 mV RMS, 10 kohm General information DC power input USB: 5V, 500mA Built-in Li-Polymer battery 3.7V 500mAH, each unit Battery working time... -
Page 8: Troubleshooting
If the problem remains unsolved, go to the Philips web site (www.philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. No power: Recharge your speaker. - Page 10 All registered and unregistered trademarks are property of their respective owners. © 2012 Koninklijke Philips Electronics N.V. All rights reserved. SBA3210_37_UM_V1.0...