Device Commands - Dell PowerEdge M420 User Manual

Dell 10Gb Ethernet Pass Through II
# login admin
& show image ver
Software image version: X.X.XXX-<date stamp>
Component #1 firmware version: Y.Y.YYY
Component #2 firmware version: Y.Y.YYY
Component #3 firmware version: Y.Y.YYY
& login user
3.5.2
copy image from-file
Synopsis:
copy image from-file [device_number]
Description:
Update the firmware on the 10GbE PTM. Immediately after running this command, the
CLI waits for the user to send the firmware image using the ZModem protocol. To abort
this operation, use CTRL-C. For additional details on the firmware update procedure refer
to
Section 4, "Operating Procedures," on page 19
ADMIN:
device_number: When this option is specified, the command will update the firmware of a
single PhyX® device, or the micro-controller software. This option specifies the device
onto which to upload the image (0..3, where 0 indicates micro-controller image)
Example:
# copy image from-file
# login admin
& copy image from-file 2# Update image on device no. 2
& login user
#
3.6

Device Commands

3.6.1
show device temp (ADMIN)
Synopsis:
show device temp device_number
Description:
Show the temperature of the specified device:
>device_number: device number from which to read temperature (1..3)
Example:
& show device temp 1
Device no. 1 temperature: 42 [Celsius]
&
.
Rev 1.00
15