Using The Player As External Hdd Unit; Firmware Update - Kenwood HD20GA7 Instruction Manual

PLAYER

Using the player as external HDD unit

The player can also be used as an external HDD unit.
1
Connect the PC and player through the USB connection.
✍ [Kenwood Media Application] INSTRUCTION MANUAL [Connection of the PC and player] 5
2 Launch the Explorer on the PC.
The PC recognizes the player as an external HDD unit.
3 Open [HD20GA7].
The same effect is also available by clicking on [Start] \ [My Computer] and then double-clicking on [HD20GA7].
When using the player as an external HDD, be careful not to initialize it by mistake.
Should the player is initialized by mistake, it is required to restore the firmware.
✍ [Kenwood Media Application] INSTRUCTION MANUAL [How to restore the firmware] ¤
POINT :
After deletion of the audio data, the contents of a library, etc. become different between the player and Kenwood
Media Application.
In this case, the consistency can be recovered by performing either operation below.
✍ [Kenwood Media Application] INSTRUCTION MANUAL [Updating of libraries] ∞
✍ [Kenwood Media Application] INSTRUCTION MANUAL [Setup/transfer of sync folder] §

Firmware Update

The latest information and procedure to update your HD20GA7 Firmware can be found in the "Technical Sup-
port" / "Service" section on the website of your resident country (if necessary you can find a link to your local
website on www.kenwood.com <http://www.kenwood.com>).
EN
39
Application section