Advertisement
Replacing the ROM
q Quit system operation, switch power off, and pull
out the power plug from the electrical outlet.
w Remove the case cover from the computer, then the
JOG board. Before removing it, be sure to read the
Operating Instructions for the DVEdit Operating
Panel Kit AY-RP500, and reverse the mounting
procedures.
e Place the removed JOG board on an antistatic mat
or the like, and remove the ROM from the JOG
board.
[How to Use Remover]
Insert the hooks at the ends of the remover into the two
diagonally located holes in the ROM socket as shown in
Figure 1, and grip the remover as shown in Figure 2.
* Never forcibly pull the remover upwards.
The ROM can be removed by lifting it out of the socket.
Mark the removed ROM with red ink, for example, so it
will not be mistaken for a new ROM.
Caution: Insert the hooks at the ends
Fig. 1
-4-
of the remover all the way in, then
pull out the ROM.
There is the danger of damaging
the ROM if the remover is not fully
inserted.
Hook
Fig. 2
Advertisement
