Solo Function - Yamaha 02R Version 2 Manual

Solo function

When two or more 02R units are cascaded together, only the [SOLO] button
on the cascade master continues to function. When you press the [SOLO]
button on the cascade master, however, you can solo individual channels
on the cascade slaves.
1. On the 02R cascade master, use the [SETUP] button to locate the
SETUP 1/4 page.
2. Select the "Mode" field with the CURSOR buttons to set the solo
function status.
You can only set this status on the cascade master.
See "Solo" on page 196 of the User's Guide for further details.
3. On the 02R cascade master, press the [SOLO] button.
The LEDs inset in the [ON] buttons of all the cascaded 02R units will
flash.
4. Press the [ON] button of the channel (or channels) that you want
to solo.
In Recording mode, the channel signal is sent to the Solo bus on the
cascade master, and you can monitor the signal using the monitor
system connected to the cascade master. In Mixdown mode, the
channel signal is sent to the Stereo bus.
Installing Options
02R User's Guide
233