Configure The Network With The Computer - Sanyo Network Board MD13NET Owner's Manual

Installation

Configure the network with the computer

B
This example explains how to set the following configuration.
IP Address
Subnet Mask
Default Gateway : 192.168.1.1
DNS
The default network configuration is set as follows.
IP Address
Subnet Mask
Default Gateway
DNS
Make sure that the projector is connected to the network and then turn the projector
on.
1
Temporarily*
number as the Network Board. For example, change your computer network con-
figuration as follows and restart the computer.
IP Address
Subnet Mask
Default Gateway
DNS
The network configuration of computer differs depending on each network environ-
ment or your computer. For further information, please see the next chapter
"Configure the network of computer".
*1 Change your computer's network configuration temporarily. After completing the set up for
the projector, you must set up again to the original network configuration for your computer.
It is recommended to make a note of those network settings.
18
: 192.168.1.201
: 255.255.255.0
: 0.0.0.0
: 192.168.0.2
: 255.255.255.0
: 0.0.0.0
: 0.0.0.0
set up your computer network configuration to the same IP network
1
: 192.168.0.2
: 255.255.255.0
: (blank)
: (blank)