Yamaha CP1 Owner's Manual page 52

Common Settings
Zone Edit Screen
The Zone Edit screen can be accessed in order to setup keyboard zones whenever KbdMode has been set to "zone"
(see page 51). This screen extends over two individual pages.
First page: Note limits and program-change settings
Editing Sequence:
Zone
NoteLimit
(Note Limits)
BankMSB
(Bank Select MSB)
BankLSB
(Bank Select LSB)
PCNum
(Program Change Number)
Second page: Zone-specific MIDI controllers
Editing Sequence:
Zone
MIDI
(Transmit MIDI Switch)
PtchBend
(Pitch Bend Wheel)
FC1 (Foot Controller 1)
FC2 (Foot Controller 2)
SusPedal (Sustain Pedal)
52
CP1 Owner's Manual
Press the [COMMON] button  Turn Knob 5 to set KbdMode to "zone"  Press Knob 6 (ZoneEdit)
This parameter is used to select the zone to be edited. As shown in the following table, the destination for
MIDI messages and the MIDI channel are fixed for each zone.
Setting values: zone1, zone2, zone3, or zone4
Zone
zone1
zone2
zone3
zone4
These parameters are used to define keyboard sections for the currently selected zone. Specifically, Knob 2
is used to set the lowest note in a section; Knob 3 is used to set the highest.
Setting values: C -2 to G8
NOTE If you setup a section with the lowest note higher than the highest note — for example "C5 – C4" — it will
wrap around the top and bottom of the keyboard. That is to say, in the case of our example, the section in
question would extend from C -2 to C4 and from C5 to C8.
These parameters are used to choose a voice on an external MIDI device for use with the currently selected
zone. Specifically, Knobs 4 to 6 can be turned to set the bank select MSB, the bank select LSB, and the
program change, respectively. The actual voice selected will depend on the other MIDI device being used.
Setting values:
Bank MSB ....0 to 127
Bank LSB .....0 to 127
PC ................1 to 128
Furthermore, Knob 4 and Knob 6 can be pressed to turn on and off the sending of the program-change
messages set here. It should be noted that this setting takes effect only when the MIDI (Transmit MIDI
Switch) is set to "on" (see the following parameter).
Setting values: off or on
Press the [COMMON] button  Turn Knob 5 to set KbdMode to "zone"  Press Knob 6 (ZoneEdit) 
Press the [PAGE ] button
This parameter is used to select the zone to be edited, and it is linked with the corresponding parameter
from this screen's first page.
Setting values: zone1, zone2, zone3, or zone4
This parameter is used to turn on or off the transmission of MIDI messages for the currently selected zone.
Setting values: off or on
These parameters are used to turn on or off the transmission of MIDI messages generated by the Pitch
Bend wheel, Foot Controller 1, Foot Controller 2, and the Sustain pedal from the currently-selected zone.
The settings made using these parameters take effect only when the MIDI (Transmit MIDI Switch) parameter
is set to "on".
Setting values: off or on
Destination Send channel
Part 1
Part 2
External MIDI device
External MIDI device
Receive channel
1 1
2 2
3 —
4 —