HP 4510s - ProBook - Celeron 1.8 GHz User Manual page 30

16. Slide the top cover back until it disengages from the base enclosure, and then rest the top cover
on the computer so that the TouchPad cable is accessible.
17. Release the ZIF connector (1) to which the TouchPad cable is connected, and then disconnect the
TouchPad cable from the system board (2) by pulling upward.
18. Remove the top cover (3) from the computer to expose the hard drive and WLAN compartment.
19. Remove the 2 hard drive screws (1) and loosen the captive screw (2) that secure the hard drive.
20. Use the Mylar tab (3) on the hard drive to slide the hard drive to the right to disconnect it from the
system board.
26 Chapter 6 Replacing the hard drive