HP Designjet 3D User Manual page 16

Canceling the cleaning cycle
To cancel the cleaning cycle at anytime, press the cancel button on the control panel. The system
will stop and drain the cleaning tank. Before the system completely turns off, the cleaning tank
may refill with water for a final rinse (depending on where the system is in the cleaning cycle)
and then drains again. After the cleaning tank has drained, the lid unlocks so the model basket
can be removed. The drained solution cannot be reused. Models may not be fully cleaned if you
cancel the operation.
Process error LED
A flashing yellow process error LED indicates a warning. See
details.
A red process error LED indicates that the system is experiencing a system error. See
"Troubleshooting" on page 14
Turning the system off
Once the cleaning cycle is complete and the models have been removed, the system should be
turned off by toggling the power switch on the back panel to the OFF position. If the system is
not going to be used for an extended period of time, remove all models from the model basket,
make sure the system is completely dry, and the power cord is disconnected from the power cord
receptacle.
12 Chapter 4 Operation
for details.
"Troubleshooting" on page 14 for