Yamaha YSP 800 - Digital Sound Projector Five CH Speaker Owner's Manual page 100

YSP-800 QUICK REFERENCE GUIDE
This quick reference guide explains steps to connect a TV and a DVD player to this unit and achieve the surround sound effects in a quick, easy manner.
Before installing this unit
This unit creates surround sound by reflecting projected sound beams off the walls of your listening room.
The surround sound effects produced by this unit may not be sufficient when the unit is installed in the following locations.
• Rooms with surfaces inadequate for reflecting sound beams
• Rooms with acoustically absorbent surfaces
• Rooms with measurements outside the following range W (3 to 7 m) x H (2 to 3.5 m) x D (3 to 7 m)
• Rooms with less than 2 m from the listening position to the speaker positions
• Rooms where objects such as furniture are likely to obstruct the path of sound beams
• Rooms where the listening position is close to the walls
• Rooms where the listening position is not in front of this unit
Make sure you leave an adequate amount of ventilation space so that heat can escape. Make at least 5 cm of space above or below this unit.
1. Installing this unit
Install this unit where there are no obstacles such as furniture obstructing the path of sound beams. Otherwise, the desired surround sound effects may not be achieved.
You may install this unit in parallel with the wall or in the corner.
Parallel installation
Install this unit in the exact center of the wall when it
is measured from the left and right corners.
An object, such as furniture
Installation example
Install this unit so that the sound beams
can be reflected off the walls.
Wrong
Printed in Malaysia WG29100
Side view
5 cm or more
Front
Corner installation
Install this unit in the corner at a 40º to 50º angle from
the adjacent walls.
40° to 50°
An object, such as furniture
Correct Correct
2. Connecting external components to this unit
Connect this unit to external components such as your TV, DVD player, VCR, digital satellite tuner, cable TV tuner, game console and a subwoofer.
■ Connecting a TV and a DVD player
Connect a TV and a DVD player to this unit. If you connect a subwoofer to this unit, you can enjoy reinforced low bass sounds.
Note
For further information on connecting other components, see pages 14 to 20 in the supplied Owner's Manual.
DVD player
Optical
digital
output
Rear
Optical cable (supplied)
VCR TV/STB SUBWOOFER VIDEO
AUDIO INPUT
OUT
OPTIMIZER MIC
To the AC outlet
■ Installing the optimizer microphone
The supplied optimizer microphone collects and analyzes the sound that this unit produces in your actual listening environment. Refer to the following two diagrams to install the optimizer
microphone in a proper location once it is connected to this unit. If you use a tripod or the supplied cardboard microphone stand to affix the optimizer microphone, try to place the optimizer
microphone at the same height as your ears would be when you are seated in your listening position.
Optimizer microphone position
More than 2 m
Video
output
Video
input
DVD video pin cable
1
2
OSD video pin cable (supplied)
Subwoofer pin cable
(in case you connect a subwoofer)
Audio pin cable (supplied)
Optical cable
(in case of an optical digital connection)
Monaural
input
TV/STB AUX DVD SYSTEM
OPTICAL COAXIAL CONNECTOR
DIGITAL INPUT
Rear panel of this unit
This unit
(U.S.A. and Canada models)
Optimizer microphone (supplied)
Using a tripod Using the supplied cardboard microphone stand
Optimizer microphone position
Within 1 m
More than 2 m
Within 1 m
Tripod
TV
Analog Optical
audio digital
output output
L
R
Subwoofer
Within 1 m
Within 1 m
Cardboard
microphone stand
© 2005 All rights reserved.