Initialization Of Data - Sony DSCW1 - Cybershot 5MP Digital Camera Service Manual

1-7.

INITIALIZATION OF DATA

1. Initializing All Page Data
By performing the following procedure, data of all pages will be
initialized.
Note: If all page data have been initialized, all adjustments need
to be performed again.
Initializing Method:
1) Select page: 00, address: 01 and set data: 01.
[Sector Write]
2) Click on the SEUS screen to display the SEUS
SECTOR WRITE screen.
3) Check that the SET ID is "0A".
[All]
4) Click of the ALL SELECT buttons to select all pages.
(Fig. 6-1-56 A)
[Write]
5) Click to write the initializing data to the flash memory
of the camera.
6) Wait for 3 sec.
[Close]
7) Click to close the SEUS SECTOR WRITE screen.
8) Select page: 8E, address: 00 and set data: 20.
[Save]
9) Click on the SEUS screen.
10) Wait for more than 3 sec.
11) Select page: 80, address: 30, and check that the data is "00".
Processing after Completing Initializing
Order Page Address Data
[Set]
1 20 00 29
[Set]
2 20 01 29
Note: At this time, the camera is reset and the power is turns off
once and then on again. Accordingly, the message "Re-
ceive Packet Error" is displayed on the SEUS screen, and
the SEUS goes in "disconnect" state, but this is not a
[Connect]
trouble. Click
the "connected" state. (In case that the power does not turn
on again, press the power button.)
B
A
Fig. 6-1-56
Procedure
(Note)
on the SEUS screen to restore
0A
2. Initializing Single Page Data
By performing the following procedure, data of the page that you
want to initialize will be initialized.
Note 1: If the 6D or 6E or 6F page data have been initialized, the
following adjustment needs to be performed again.
1) Camera system adjustments
Note 2: If the 8F page data have been initialized, the following
adjustment needs to be performed again.
1) Video system adjustments
2) LCD system adjustments
Initializing Method:
1) Select page: 00, address: 01 and set data: 01.
[Sector Write]
2) Click
SECTOR WRITE screen.
3) Check that the SET ID is "0A".
4) Click "All" of the option buttons of target page. (Fig. 6-1-56
B)
[Write]
5) Click to write the initializing data to the flash memory
of the camera.
6) Wait for 3 sec.
[Close]
7) Click to close the SEUS SECTOR WRITE screen.
8) When 8E page is initialized, select page: 8E, address: 00 and
set data: 20.
[Save]
9) Click on the SEUS screen.
10) Wait for more than 3 sec.
11) Select page: 80, address: 30, and check that the data is "00".
Processing after Completing Initializing
Order Page Address
1 20 00
2 20 01
Note: At this time, the camera is reset and the power is turns off
once and then on again. Accordingly, the message "Re-
ceive Packet Error" is displayed on the SEUS screen, and
the SEUS goes in "disconnect" state, but this is not a
[Connect]
trouble. Click
the "connected" state. (In case that the power does not turn
on again, press the power button.)
6-25
DSC-W1/W12
on the SEUS screen to display the SEUS
Data Procedure
[Set]
29
[Set]
29 (Note)
on the SEUS screen to restore