HP Workstation xw4100 User Manual page 29

Use the following steps as a guide to set up the LSI 8344ELP or the LSI 8888ELP or SAS RAID. Details
will vary based on the specific configuration used.
1. Boot the workstation, and when prompted, press CTRL-H to enter LSI's WebBIOS utility. WebBIOS
will be run after POST completes. Select the desired adapter from the Adapter Selection screen
and press start to enter the utility.
Figure 6-8
2. The main WebBIOS screen can be used to configure the adapter, the physical disks, and the virtual
disks or RAID arrays. The first view shows the physical disks connected to the adapter, any RAID
arrays presently configured, as well as the status of both physical and virtual disks.
Figure 6-9
ENWW
LSI WebBIOS – Adapter selection
LSI WebBIOS – Main screen
LSI 8344ELP and LSI 8888ELP Setup 25