HP Xw4400 - Workstation - 2 GB RAM Installation Manual page 7

Cru dataport dx115 kit

Hide thumbs Also See for Xw4400 - Workstation - 2 GB RAM:

Step 4—Completing the workstation assembly

CAUTION:

Other procedures may result in system hangs, data loss or even drive damage. (The component

supplier's user guide describes a procedure for inserting or removing the carrier (with drive) while the

workstation is booted and then powering the drive via the enclosure's power switch. Microsoft Windows

XP and Vista do not support this action.)

After the drive is installed in the carrier. Insert the drive carrier in the case. Press the handle in (1)

and use the key (2) to lock the carrier if shipping the unit (3).

Connect the power (1) and data (2) cables to the primary (upper) ports on the unit.

To prepare your installed hard drive for operation, refer to the appropriate hard drive

documentation.

If shipping the unit, use the key to lock the carrier and install the shipping screw as described in

the previous steps.

ENWW

Insert or remove the carrier (with a disk drive) only when the workstation is shut down.

Step 4—Completing the workstation assembly

Table of Contents