HP Xw4550 - Workstation - 2 GB RAM Installation Manual page 8

CAUTION:
to the drive when moving the workstation.
NOTE:
securing an optional drive.
6. As shown below, connect the workstation power supply power cable (1) to the drive. Then connect
the SATA interface cable (2) between the drive and the next available SATA connector on the
workstation system board.
NOTE:
board, either end of the interface cable (straight or right-angle connector) can be connected to the
drive. Select an interface cable from the kit that best fits the length and connector required by your
workstation.
NOTE:
capability for this drive, refer to the "Enabling digital audio" section that follows.
8 SATA optical drive installation
Failure to ensure that the optical drive has been properly secured may cause damage
Refer to the documentation included with your workstation for specific instructions on
Although a general recommendation is to plug the right-angle connector into the system
The SATA Optical Drive does not have an audio cable receptacle. To obtain audio
ENWW