HP Xw4550 - Workstation - 2 GB RAM Installation Manual page 4

5. Align the screw holes in the tray with the screw holes at the rear of the workstation (1).
Figure 3
6. Use a T-15 Torx driver to fasten the tray to the workstation with the two chassis screws set aside
in Step 1.
Step 3—Mounting the workstation rack
1. Attach the rails to the rack. Refer to the rail installation instructions in this kit.
2. Remove the adhesive backing from the back of the guide strips.
3. Apply a guide strips to the top surface of each rail.
Figure 4
4. Place the workstation with the attached tray (1) onto the rails (2) in the rack.
5. Slide the workstation all the way into the rack.
6. Use a cross-tip screw driver to secure the workstation to the rail mounting flanges with two M6
screws (3).
Figure 5
Step 4—Completing installation
After installation, restore power and power up the workstation.
4 Rack mount tray installation
Fastening the tray to the workstation
Applying glide strips
Fastening the workstation to the rack
ENWW