HP Z600 - Workstation - 6 GB RAM Installation Manual page 4

Step 2—Installing the PCIe NIC hardware
1. To install the NIC in the selected PCIe slot:
a.
b.
Figure 2
2. For workstations that support DASH, attach the USB cable provided to the USB connector on
the NIC (3), and then to the DASH-enabled USB dual (10–pin) header on the system board (4).
NOTE:
panel. For information to determine DASH compatibility, see
Figure 3
4 Broadcom NetXtreme Gigabit Ethernet Plus Network Interface Card installation
Verify the keyed components of the card align with the socket (1).
Close the PCI levers (2).
Installing the NIC
To locate the DASH-enabled USB, see the service label inside the workstation access
Connecting the USB cable for DASH-enabled workstations
Before you begin on page 1.
ENWW