Install Disk Modules; Figure 4. Installing Disk Modules - HP D5970A - NetServer - LCII Configuration Manual

Install Disk Modules

NOTE
CAUTION
1. Pull out the module lever.
2. Insert the module into the disk array.
3. Push in the module lever to lock the module in place.
To improve enclosure cooling and balance the load on the internal SCSI buses, the disk
modules should be installed from left to right and from top to bottom. Disk module SCSI
addresses are automatically preset by the backplane inside the disk array enclosure upon
insertion.
The module lever must be pulled all the way out or the module will jam in the slot upon
insertion. Also, always handle the disk modules carefully when they are out of the disk
array enclosure, since they are susceptible to shock and vibration.

Figure 4. Installing Disk Modules

9