HP D6030A - NetServer - E50 Installation Manual page 22

Chapter 3
Power
System Board
Switch
IDE1
IDE2
Flexible Disk
Controller
Flexible Disk
Shelf 1
CD-ROM Shelf 2
Shelf 3
Shelf 4
For cabling options and connector locations, see the
Technical Reference Label inside your HP NetServer chassis.
Figure 3-1. NetServer E 45 Shelf Positions and Cabling Options
Use the guidelines in Table 3-1 to determine the proper location within
your HP NetServer E 45 to install your hard disk drive.
Table 3-1. Mass Storage Device Locations and SCSI ID Settings
Device
Standard Hard Drive
(in models that
include one)
HP Accessory 9 GB
HD (P1213A)
HP SureStore T4i
HP SureStore 8i,
5000i, 2000i
Standard SCSI
Controller
If the drive is in a factory-provided tray, place the drive on a flat surface
free from static electricity with the circuit board on the drive facing up.
Remove the four screws that attach the drive to the tray and remove the
drive. (These screws can be used to mount the drive in the HP NetServer
E 45.)
18
Mount the Drive in the NetServer E 45 or E 50
F5
SCSI Card
C33
PCI 1
D5
Shelf 5
*
Shelf 6
Location SCSI Address
Shelf 5 0 (default)
Shelf 3, 4, 5 0, if it is the first hard drive; for
or 6 subsequent drives, use address 1, 2
or 3
Shelf 3 or 4 4 (default)
Shelf 3 or 4 2 (default)
(can be set to any unused address)
PCI 1 Slot 7
Key
Available Connector
Engaged Connector
C33 50-pin SCSI Cable
D5
IDE CD-ROM Cable
Flexible Disk Cable
F5
* Built-in SCSI Terminator