HP D7171A - NetServer - LPr Installation Manual page 25

Chapter 2
6. Reattach the lower fan module:
a. On each side of the back of the fan module are two slots. Line these
slots up with the flanges on the fan's mounting rails.
b. Push the fan module onto the mounting rails until it clicks into place.
7. Reattach the satellite chassis to the base chassis:
a. When you finish servicing the HP NetServer, move to the front of the
server and unlatch all four power supplies. (If the front bezel is in
place, remove it.)
b. At the rear, insert the satellite chassis. To do so, push in the release
latch for each slide (Figure 2-14). While holding the latches down,
push the satellite part way onto the base, so that the latches can no
longer engage.
c. If you do not depress these two latches, the satellite cannot move all
the way onto the base chassis.
Installing Memory in the 4 GB Memory Board
Release
Latch
Figure 2-14. Unlocking the Slides
Push down the
release latches
on each slide. Then
push the satellite
partly onto the base
chassis.
21