HP D7171A - NetServer - LPr Manual page 5

Pci card installation and replacement and hot-plug operations

Hide thumbs Also See for D7171A - NetServer - LPr:

Chapter 6 Addendum

By default the NetServer searches for boot devices in this order:

1. IDE CD-ROM drive

2. Flexible (Floppy) disk drive

3. PCI Slot P1

4. SCSI A bus

SCSI device ID 0

SCSI device ID 1

SCSI device ID 15

5. SCSI B bus

SCSI device ID 0

SCSI device ID 1

SCSI device ID 15

6. PCI slot 2

7. PCI slot 3

8. PCI slot 4

9. PCI slot 5

10. PCI slot 6

11. PCI slot 7

12. PCI slot 8

13. PCI slot 9

14. PCI slot 10

NOTE

The NetServer can be configured to boot by default from a PCI accessory board instead of the

onboard SCSI channels by putting the board in slot P1. The NetServer can also be configured to

boot from a PCI-based DAC inserted into a PCI slot in the I/O baseboard. The SCSI

Configuration Utility can be used to configure the server to skip over the onboard SCSI channels

and select a different PCI slot when scanning for boot devices. For instructions, refer to the SCSI

Configuration Utility on the Information Assistant CD-ROM under LXr 8000/Configure/

Hardware Configuration Utility/SCSI Configuration Utility.

HP NetServer LXr 8000 Installation Guide

Table of Contents