Slide Out The Satellite Chassis - HP D7171A - NetServer - LPr Upgrade Manual

Chapter 3
NOTE After you unlock the power interlock switch, there is no power
present at any internal or externally accessible area of the
satellite chassis. However, five volts of power are present at
the power supply pins on the base chassis where the satellite
attaches. To remove all power, unplug the AC power cord.

Slide Out the Satellite Chassis

CAUTION
Wear a wrist strap and use a static-dissipating work surface
connected to the chassis when handling components. Ensure
that the metal of the wrist strap contacts your skin.
1. Put on the antistatic wrist strap and place the antistatic mat on a firm
surface near the system. Connect the strap and mat to an unpainted metal
surface on the system chassis.
2. Look at any cables you might have connected to PCI cards. If there is not
enough slack in one or more cables to pull out the satellite chassis,
disconnect the cables as necessary.
3. Remove the retention bracket from the lower rear of the NetServer and set
it aside. See Figure 3-3.
CAUTION
You will need to replace the retention bracket when
redocking the Satellite Chassis. The bracket ensures correct
mechanical connection.
Perform the Upgrade
9